AskMaher Answers > Cars

Q: how to replace the turn signal combination switch in a subaru outback ?

  Answers: 0 Views: 489 till

Add Your Answer/Comment


Guest Comments will be reviewed before published Tell a friend


(Only Registered Users See Yes/No Subscribe link)

Report broken Rate: 0.00 0.00 0.00 0.00 0.00







Suggested Answers



locate cables for the power button reset switch and hard drive LED. The cables are connected to the front plate of the pc case then flip the cables over to read the names labeled on the connectors label for the hard drive cable reads HDD LED check motherboard manual for the locations of the pn 1 and pn 2 connector then find the set of pins for the power and the reset switch and hard drive LEDs the pins are typically labeled PWSW RESW and LED ((black wire of each cable to the pin labeled GND (( ground


Source: how i install power reset switch and hard drive led on a pc

(497 views, 1 answers)


on this page i read how turn off the camera sound on my blackberry curve it is works with me


Source: how do i turn off the camera sound on my blackberry curve

(669 views, 1 answers)


try to replace the light switch maybe some damage there and it is not working fine, some electricity leak maybe there


Source: i have a 2005 hyundai tiburon gt v6 and the headlights keep going out everytime i turn on my blinker

(305 views, 1 answers)


just wondering how you go about changing the turn signal relay on an oldsmobile alero


Source: how to replace turn signal relay in a oldsmobile alero

(607 views, 1 answers)



Source: color combination examples

(382 views, 0 answers)



Source: how to find the check engine codes on a subaru impreza

(567 views, 0 answers)